Garmin GHP 12 Manual de instrucciones de instalación - Página 8
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Equipamiento marino Garmin GHP 12. Garmin GHP 12 32 páginas. Drive unit and rudder feedback unit wiring reference
También para Garmin GHP 12: Manual de referencia (2 páginas)
Imprimir página
General Component Layout Diagram
Refer to this diagram for component-layout reference only. Follow the detailed installation instructions for each component
Item
Description
GHC 10
➊
12-24 Vdc battery
➋
CCU
➌
Drive unit
➍
ECU
➎
NMEA 2000 network
➏
8
➋
➍
➎
Important Considerations
In order for the autopilot to turn on, the yellow wire from the GHC 10 data cable must be connected to the
yellow wire from the CCU/ECU Interconnect cable, and the black wire from the GHC 10 data cable must
be connected to the same ground as the ECU
The ECU can connect to a 12–24 Vdc power source.
The NMEA 2000 power cable must be connected to a 9–16 Vdc power source.
The CCU must be installed in the front half of the boat,
Do not cut or extend the drive unit cables.
If you are using the GHP 12 with a non-Garmin drive unit, you must purchase a GHP 12 drive unit cable
(page
9).
The ECU can either be connected to a 12 or a 24 Vdc battery.
The GHC 10 and the CCU must be connected to the NMEA 2000 network using the included T-connectors
(page
12).
If there is not an existing NMEA 2000 network on your boat, you can build one using the supplied cables
and connectors
(page
13).
➊
➏
(page
12).
no higher than 10 ft. (3 m) above the waterline
(pages
9–14).
➌
GHP 12 Installation Instructions