AEG FAVORIT 403 Manual de instrucciones - Página 29

Navegue en línea o descargue pdf Manual de instrucciones para Lavavajillas AEG FAVORIT 403. AEG FAVORIT 403 32 páginas. Aeg dishwasher user manual

Proceed as follows:

Remove the machine's worktop by unscrewing the two rear retaining screws,

pull from the front and slide out the slots, lifting the worktop.

Insert the machine after adjusting the level with the adjustable feet.

When inserting the machine, ensure that the water inlet and drain hoses are

not kinked or squashed.

Connecting the water supply

Your dishwasher has been built in accordance with the valid regulations

governing water-consuming appliances and is equipped with safety devices

which prevent used water from flowing back into the drinking water mains.

Your dishwasher can be connected to either a cold or hot water supply of

max. 60°C.

Never connect your dishwasher to open hot water appliances and continuous

flow heaters!

The supply hose is fitted with a screwed hose connection (to DIN 259) and

can be connected to an outlet valve (water tap) with male thread (3/4").

Suitable washers are supplied with the machine. Do not use any washers

other than these!

The nut of the screwed hose connection can be tightened by and. If you re-

quire a supply hose which is longer than the one supplied, use only the VDE-

approved complete hose kit (obtainable from our service centre) continuously

and to adequate length.

Never lengthen existing hoses.

Important note! The supply hose must not be kinked, squashed, or twisted.

Please ensure careful running.

To avoid reductions in water supply to the kitchen, we recommend you to

install a separate tap. Failing this, fit a branch piece to the existing water tap.

Additional installation expenditure (on the building side) can be reduced by

use of conventional sink mixers with connection and shutoff valve.