Garmin GTX 320A Manual de instalación - Página 12
Navegue en línea o descargue pdf Manual de instalación para Radio marítima Garmin GTX 320A. Garmin GTX 320A 37 páginas. Garmin gtx 320/320a transponder installation manual
También para Garmin GTX 320A: Manual del piloto (4 páginas), Manual del piloto (8 páginas), Manual de instalación (43 páginas)
Imprimir página
A.
Trim coax outer insulation back 0.50".
B.
Trim braid (not center conductor or insulation) back 0.25".
C.
Strip Insulation back 0.120".
Place the ferrule over the coax braid, flush against the coax outer insulation before performing the
next step if the outside diameter of the coax braid is smaller than the inside diameter of the center
connector sidewall opening.
D.
Insert cable (center conductor, dielectric and shield braid) through the sidewall of the connector and
solder the center conductor to the center pin of the connector.
When using low loss cable it may be necessary to flatten the solid wire center conductor slightly so
it can fit the slot on the RF connector center pin. When soldering, avoid applying excess heat to the
connector body, and center conductor insulator.
E.
Heat the outside of the connector sleeve and at the same time apply solder between the braid and the
sleeve. Continue to apply heat until the solder flows evenly.
F.
Install 50
G.
Insert connector cap and tack solder in two places.
Page 8
Rev L
Matching Bushing.
NOTE
NOTE
GTX 320/320A Installation Manual
190-00133-01