AEG FAVORIT 620 Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Lavavajillas AEG FAVORIT 620. AEG FAVORIT 620 16 páginas. Dishwashers
También para AEG FAVORIT 620: Manual de instrucciones (16 páginas), Manual de instrucciones (16 páginas)

Imprimir página

Control/Interior view

Please unfold pages 3, 4, 5, for easy reference.

Control panel

Figure 1

A ON/OFF and programme buttons

B Door handle

C Signal indicators

Programme sequence indicator

Inside view

Figure 2

Lower spray arm

Salt container

Water hardness adjuster

Detergent dispenser

Rinse aid container

Filters

Programme summary

Rating plate (with E and F numbers)

moonwwp,Y

What to do before you use your dishwasher for the first time:

Fill the salt container with dishwasher salt

Figure 3

Your dishwasher is equipped with a water soft-

ener which transforms the "hard" water into 'soft*

water required for washing. To regenerate the

water softener special dishwasher salt is

required.

At the factory the machine has been set for a

water hardness of ¢ ¢ ¢ (from 26 to 48 degrees)

(see fig. 5).

lf the water hardness in your area is between

16— 26 degrees, set the water hardness selector

(fig. 2/B 1) to © © from 16—26 degrees) ('/, turn,

arrow pointing down).

For settings ¢ ¢ and ee e you need to fill the salt

container with dishwasher salt.

If the water hardness is below 16 degrees the

machine does not require any salt and the water

hardness setting is immaterial. Your local Water

Authority will tell you the degree of water hard-

ness in your area.

Important

The salt you require is special salt suitable for

domestic dishwashers. On no account should

table salt, cooking salt, road salt or processed

sea Salt be used, because they contain sub-

stances which interfere with the operation of the

dishwasher.

Be careful not to fill any detergents into the

salt container, this renders the water softener

ineffective.

Should the water hardness in your area vary

from time to time, use the higher setting.

The salt container filler neck is situated on the

right hand side on the bottom of the tub (fig.

2/B).

To fill the container — open the door, lift out the

lower basket, unscrew the cap marked

and place the funnel supplied with the machine

over the opening.

Before the first use only, pour 1' to 2 litres (83—4

pints) of water into the salt container. Then fill in

the salt until it is visible at the top of the con-

tainer (capacity: approx. 2 kg). During the filling

process, some water is displaced. Remove any

spilled salt from the filler neck and replace the

top firmly. Replace the lower basket.

Important

No salt residues must be left on the bottom of

the tub. To ensure that all salt residues are

removed select a rinse and hold programme

or, if you have enough used crockery, a com-

plete wash programme after the salt container

has been filled.

To replenish the salt container

Replenish the salt container when the light

appears on the indicator key (next to the symbol

G5) on the control panel (fig. 1/C).

Note

lf the water hardness is below 16 degrees the

machine does not require any salt. In this case

the light signal stays on all the time. This does

not, however, influence the operation of the

machine in any way.