AEG FAVORIT 625 i Manual de instrucciones - Página 15
Navegue en línea o descargue pdf Manual de instrucciones para Lavavajillas AEG FAVORIT 625 i. AEG FAVORIT 625 i 16 páginas. Dishwashers
También para AEG FAVORIT 625 i: Manual de instrucciones (16 páginas), Manual de instrucciones (16 páginas)
Imprimir página
Information for the installer
Water supply
To protect the drinking water supply system, your
dishwasher is fitted with an anti-syphon.
A connection to a hot water supply up to a maxi-
mum of 70 °C with a minimum pressure of 1 bar
is possible, although the machine must not be
connected to single outlet instantaneous electric
or gas heaters.
Please ensure you comply with the drinking
water regulations of your local Water Board.
The high pressure hose (%" = 10 mm, 1,35 m
long) with */," hose coupling complete with seal-
ing washers is supplied. We recommend not to
use other washers which may be of inferior qual-
ity. It is sufficient to tighten the nuts by hand but
if a spanner is used proceed very carefully.
The machine may be connected
a) directly to a tap with ," B.S.P. thread termi-
nation
b) to a T-junction on your existing tap, or prefer-
ably
c) io acompletely separate water supply in
order to avoid interference with the kitchen
water supply during operation of the machine.
Minimum water pressure: approx. 1 bar pressure
above atmospheric pressure (1 atu = approx.
1 kp/cm? = approx. 10 N/cm?.
Water discharge
ate
OS
OG ye a
Your dishwasher is fitted with a water pump,
controlled by the programme to pump off the
water up to a height of
1m. The minimum height
above floor level should always be 30 cm. (The
maximum extension, when installed horizontally,
is 3 m, at a height of 85 cm above floor level).
Should it become necessary to extend the
drainage hose, use only original extension
hoses. These are available in lengths of 2.70 and
4.0 metres under E-No 646060763 and
For less than one bar of pressure above atmos-
pheric pressure, consult the Service Department.
Maximum permissible water pressure: approx.
10 bars. For over 10 bars excess pressure, con-
nect a pressure relief valve (obtainable through
your installer).
If a longer water supply hose is needed it should
be a single run of high pressure hose available
in 2 lengths (3.50 m E-No 645 430 552 and
5 m E-No 645430553) from AEG Spare Parts
Department. Never add extensions to hoses.
Turn off the water tap if the machine is not in
use.
It is not unusual to find a small amount of water
in your new dishwasher which remains from our
thorough factory checks.
Please note (This only applies to free standing
machines with worktop fitted)
Should a dishwasher be installed next to a gas,
solid fuel or electric cooker due to lack of space,
a heat insulating panel (85 x 57.5 cm) has to be
fitted, the side facing the cooker has to be lined
with aluminium foil.
E-No 646 060764 as spares from your AEG Ser-
vice Department. The internal diameter of exten-
sion hoses must be 19 mm to allow the machine
to function correctly.
The recess at the back of the machine offers suf-
ficient space to accommodate the outlet hose for
installation to the left or right of the machine.
When connecting the outlet hose make sure that
it lies freely in the recess at the back of the
machine and is neither kinked nor crushed on
the floor. The crooked end of the drainage hose
must be hooked on or attached otherwise at a
minimum height of approx. 30 cm above floor
level.
When connecting to a trap with appliance con-
nection the internal diameter of the connection
must be 15 mm minimum. In this case the hose
must be raised to the underside of the worktop
and secured in this position before connection to
the trap.
15