AEG 21601 G Manual de funcionamiento e instalación - Página 14

Navegue en línea o descargue pdf Manual de funcionamiento e instalación para Placa AEG 21601 G. AEG 21601 G 26 páginas. Gas hob

Important safety requirements

This hob must be installed in accordance with the Gas Safety

(Installation and Use) Regulations (Current Edition) and the IEE Wiring

Regulations (Current Edition).

Detailed recommendations are contained in the following British

Standards Codes Of Practice: B.S. 6172/ B.S. 5440, Par. 2 and B.S. 6891

Current Editions.

The hob should not be installed in a bed sitting room with a volume of

less than 20 m

. If it is installed in a room of volume less than 5 m

air vent of effective area of 110 cm

is required. If it is installed in a

room of volume between 5 m

and 10 m

an air vent of effective area

of 50 cm

is required, while if the volume exceeds 11 m

no air vent is

required.

However, if the room has a door which opens directly to the outside

no air vent is required even if the volume is between 5 m

and 11 m

If there are other fuel burning appliances in the same room, B.S. 5440

Part 2 Current Edition, should be consulted to determine the requisite

air vent requirements.

The hob may be located in a kitchen, a kitchen/diner or bed sitting

room, but not in a bathroom or shower room.

Before making the cut out in the worktop ensure that there is a

minimum distance of 55 mm. between the rear edge of the hob and

the wall.

A minimum distance of 100 mm. must be left between the side edges

of the hob and any adjacent cabinets or walls.

The minimum distance combustible material can be fitted above the

hob in line with the edges of the hob is 420 mm. If it is fitted below

420 mm. a space of 50 mm. must be allowed from the edges of the

hob.

The minimum distance combustible material can be fitted directly

above the hob is 700 mm.