AEG 35600G Manual de instrucciones - Página 25

Navegue en línea o descargue pdf Manual de instrucciones para Placa AEG 35600G. AEG 35600G 28 páginas. Gas hob
También para AEG 35600G: Manual de funcionamiento e instalación (24 páginas), Instrucciones de uso e instalación (24 páginas)

Commissioning

When the hob has been fully installed it will be necessary to check the minimum flame setting. To

do this, follow the procedure below.

1) Turn the gas tap to the MAX position and ignite.

2) Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX

several times. If the flame is unstable or is extinguished follow the procedure below.

Procedure:

1) Re-ignite the burner and set to MIN.

2) Remove the control knob.

3) To adjust, use a thin bladed

screwdriver and turn the adjustment

screw until the flame is steady and

does not extinguish, when the knob

is turned from MIN to MAX. Repeat

this procedure for all burners.

Pressure Testing

1) Remove left hand pan support and front left burner cap and crown.

2) Fit manometer tube over the injector.

3) Turn on the burner gas supply and ignite another burner supply.

The pressure reading should be nominally 20mbar and must be between 17 mbar

and 25mbar.

4) Turn off the burner supplies.

Minimum adjustment screw