AEG 6562 G Libro de instrucciones e instalación - Página 7

Navegue en línea o descargue pdf Libro de instrucciones e instalación para Placa AEG 6562 G. AEG 6562 G 10 páginas.

Imprimir página

Any adjoining wall surface situated

within 200 mm from the edge of any

hob burner must be a suitable

noncombustible material for a height of

150 mm for the entire length of the

hotplate.

Any combustible construction above

the hotplate must be at least 600 mm

above the top of the burner and no

construction shall be within 450 mm

above the top of burner. A minimum

depth of 60 mm from the top of the

worktop surface must be provided

for the hotplate.

Cut-out measurements

One rectangular hole is sawn out for

the hob combination chosen.

The depth of the cut-out for any unit

is: 490 mm

Length of hole = sum of all units`

externally measured length, less 20 mm.

Mounting of Reinforcement

Beams

A reinforcement Beam, with supporting

flanges at each end, is included with

each two-burner unit. For unit

combinations, a reinforcement beam

must be used between each unit.

It is not necessary to attach the

reinforcement beam to the table surface,

as it is held in place by a specially

designed moulding, which is

incorporated in the hob units flanges.

Minimum distance

Minimum

distance

to back wall (non-

flammable material):

to side wall:

150 mm

50 mm

Reinforcement

beams

How to use

Burner markings

Symbols at each operating knob

indicate which burner is adjusted with

the control knobs.

Left front burner

Left back burner

Right back burner

Right front burner

Panel markings

Each operating knob has a ring

showing the scale of markings.

Off.

Maximum flame

Minimum flame