AEG 75552G Manual de instrucciones - Página 18

Navegue en línea o descargue pdf Manual de instrucciones para Placa AEG 75552G. AEG 75552G 24 páginas. Gas hob

Permanent Connection

In the case of a permanent connection, it is necessary that you install a double pole switch

between the hob and the electricity supply (mains), with a minimum gap of 3 mm between

the switch contacts and of a type suitable for the required load in compliance with the

current electric regulations.

The switch must not break the yellow and green earth cable at any point.

Ensure that the hob supply cord does not come into contact with surfaces with

temperatures higher than 50 deg. C.

Replacement of the cable

The connection of the voltage cable to the appliance's terminal block is of type "Y". This

means that its replacement requires the specific equipment of a technician.

In this case, only cable types H05 V2V2-F (T90) must be used. The cable section must

be suitable to the voltage and the working temperature.

The yellow/green earth wire must be approximately 2 cm longer than the phase wires.

Wiring diagram

1. IGNITOR SWITCHES

2. IGNITOR UNIT