AEG 79902 Manual de instrucciones - Página 38

Navegue en línea o descargue pdf Manual de instrucciones para Placa AEG 79902. AEG 79902 44 páginas. Electronic gas hob

Fitting the hob to the worktop

Before fitting the hob into the cut out, an

adhesive seal must be fitted to the underside

outside edge of the hob. It is essential that no

gaps are left in this seal in order to prevent

spillage near the hob seeping into the cabinet

below.

Proceed as follows:

1. Remove the pan supports, the burner caps

and crowns and turn the hob upside down,

taking care that the spark plugs and the

thermocouples are not damaged in this

operation.

2. Place the sealing gasket all around the glass

top edge as shown in Fig. 3.

3. Fit the hob in the cut out and push it down

until the glass top and the worktop make

contact, as shown in Fig. 4. The side springs

ensure centering.

A) Seal

Fig. 3

Fig. 4