AEG 95601 G Manual de instrucciones - Página 23

Navegue en línea o descargue pdf Manual de instrucciones para Placa AEG 95601 G. AEG 95601 G 28 páginas. Gas hob
También para AEG 95601 G: Instrucciones de uso e instalación (26 páginas), Manual de funcionamiento e instalación (22 páginas), Instrucciones de uso e instalación (22 páginas)

A. EARTH CONTINUITY CHECK

Appliance must be electrically disconnected - meter set on Ω (Ohms) x 1 scale and

adjust zero if necessary.

— Test leads from any appliance earth point to earth pin on plug. Resistance should be

less than 0.1 Ω (Ohm), check all earth wires for continuity and all contacts are clean

and tight.

B. INSULATION CHECK

Appliance electrically disconnected, all switches ON.

a) meter set on Ω (Ohms) x 1 scale.

Test leads from L to N in appliance terminal block. If meter reads «0» then there is a

short circuit.

b) meter set on Ω (Ohm) x 100 scale.

Repeat test with leads from L to E. If meter reads less than ∞ (infinity) there is a fault.

NOTE - Should it be found that the fuse has failed but no fault is indicated - a detailed continuity

check (i.e. by disconnecting and checking each component) is required to trace the faulty

component.

It is possible that a fault could occur as a result of local burning/arcing but no fault could be found

under test. However a detailed visual inspection should reveal evidence of burning around the

fault.