Brother HL-1020 Manual de configuración rápida - Página 36

Navegue en línea o descargue pdf Manual de configuración rápida para Impresora Brother HL-1020. Brother HL-1020 42 páginas. Brother hl-1040: quick setup
También para Brother HL-1020: Lista de referencia de piezas (16 páginas)

Imprimir página

Installing the SIMM

To install the SIMM, follow these steps:

Caution

SIMM boards may be damaged by even a small amount of static electricity. Do not touch the

memory chips or the board surface. When handling the board and before installing or

removing it, wear an antistatic wrist strap, or frequently touch the surface of the antistatic

package or bare metal on the printer.

4. Install the main controller board into the printer by sliding it into the guide rails.

5. Secure the main controller board with the four screws.

6. Reconnect the interface cable (printer cable) from your computer. Plug the power cord into

the AC outlet and turn on the power switch.

7. To check that the SIMM is installed correctly, you may perform a Test Print "Print

Configuration" which will print the current total memory size.

Turn off the power switch and unplug the p

cord from the AC outlet. Disconnect the inte

cable (printer cable) from the printer.

Caution

Be sure to turn off the power switch and

unplug the power cord to the printer

before installing or removing the SIMM

to/from the main controller board.

Unscrew the screws securing the rear

plate of the main controller board to the

printer and pull out the main controller

board .

Unpack the SIMM and hold it by its edge.

Install the SIMM into the slot and push it

gently towards the vertical until it clicks

into place.