TROUBLESHOOTING
Check the following before calling for service.
No image appears
Is the power cord of the display
connected?
Do you see an "Out of Range" message
on the screen?
Do you see a "NO SIGNAL" message on
the screen or black screen?
Can't you control some functions in OSD?
Can't you select some menu in
OSD?
CAUTION
Check Control Panel ► Display ► Settings and see if the frequency or the resolution were changed. If yes,
y
readjust the video card to the recommend resolution.
If the recommended resolution (optimal resolution) is not selected, letters may be blurred and the screen may be
y
dimmed, truncated or biased. Make sure to select the recommend resolution.
The setting method can differ by computer and O/S (Operation System), and resolution mentioned above may
y
not be supported by the video card performance. In this case, please ask to the computer or the video card
manufacturer.
Keep proper posture when using the monitor, otherwise the screen may not be optimized.
y
Display image is incorrect
The screen color is mono or abnormal.
The screen blinks.
Do you see an "Unrecognized monitor, Plug&Play (VESA DDC) monitor found" message?
Have you installed the display driver?
The screen is flickering.
Did you select the recommended
resolution?
y Check and see if the power cord is connected properly to the power outlet.
y This message appears when the signal from the PC (video card) is out of horizontal or
vertical frequency range of the display. See the 'Specifications' section of this manual
and configure your display again.
y After the monitor is on "NO SIGNAL", the monitor goes to DPM mode.
y This is displayed when the signal cable between the PC and the monitor is missing or
disconnected. Check the cable and reconnect it.
y Check PC status.
y You can unlock the OSD controls at any time by entering the OSD lock menu and
changing items to off.
y Check if the signal cable is properly connected and use a screwdriver to fasten if
necessary.
y Make sure the video card is properly inserted in the slot.
y Set the color setting higher than 24 bits (true color) at Control Panel ► Settings.
y Check if the screen is set to interlace mode and if yes, change it to the recommend
resolution.
y Be sure to install the display driver from our web site: http://www.lg.com .
y Make sure to check if the video card supports Plug&Play function.
22MK4 series 24MK4 series 27MK4 series 22MN430H
y
24MN430H
If the selected resolution is HDMI 1080i 60/50 Hz, the screen may
be flickering. Change the resolution to the recommended resolution 1080P.
21
Imprimir página