AEG 7332543582556 Manual del usuario - Página 4
Navegue en línea o descargue pdf Manual del usuario para Lavadora AEG 7332543582556. AEG 7332543582556 28 páginas.
Imprimir página
4
www.aeg.com
Do not exceed the maximum load of 6 kg (refer to the
•
"Programme chart" chapter).
The operating water pressure at the water entry point
•
from the outlet connection must be between 0.5 bar
(0.05 MPa) and 8 bar (0.8 MPa).
The ventilation opening in the base must not be
•
covered by a carpet, mat, or any floor covering.
The appliance must be connected to the water mains
•
using the new supplied hose sets, or other new hose
sets supplied by the Authorised Service Centre.
Old hose sets must not be reused.
•
If the mains power supply cable is damaged, it must
•
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
Before any maintenance operation, deactivate the
•
appliance and disconnect the mains plug from the
socket.
Do not use high pressure water sprays and/or steam
•
to clean the appliance.
Clean the appliance with a moist cloth. Use only
•
neutral detergents. Do not use abrasive products,
abrasive cleaning pads, solvents or metal objects.
2. SAFETY INSTRUCTIONS
2.1 Installation
The installation must comply
with relevant national
regulations.
• Remove all the packaging and the
transit bolts including rubber bush
with plastic spacer.
• Keep the transit bolts in a safe place.
If the appliance is to be moved in the
future they must be reattached to lock
the drum to prevent an internal
damage.
• Always take care when moving the
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
• Do not install or use a damaged
appliance.
• Follow the installation instructions
supplied with the appliance.
• Do not install or use the appliance
where the temperature can be less
than 0°C or where it is exposed to the
weather.
• The floor area on which the appliance
is to be installed must be flat, stable,
heat resistant and clean.
• Make sure that there is air circulation
between the appliance and the floor.
• When the appliance is in its
permanent position, check if it is
levelled correctly with the aid of a
spirit level. If it is not, adjust the feet
accordingly.
• Do not install the appliance directly
above a floor drain.