Brother P-TOUCH CUBE PT-P300BT Manual del usuario - Página 14
Navegue en línea o descargue pdf Manual del usuario para Etiquetadora Brother P-TOUCH CUBE PT-P300BT. Brother P-TOUCH CUBE PT-P300BT 18 páginas. Tze tape
También para Brother P-TOUCH CUBE PT-P300BT: Manual del usuario (18 páginas), Manual del usuario (18 páginas), Manual del usuario (18 páginas), Manual del usuario (18 páginas), Manual del usuario (18 páginas)
Imprimir página
3. Inserting the Tape Cassette
Make sure your Tape Cassettes display the TZe mark (
Use only tape widths of 3.5 mm, 6 mm, 9 mm, or 12 mm.
If there is a stopper on the TZe Tape Cassette, remove it before installation.
1. Hold the label printer as shown in the
illustration. Open the Cassette Cover
by pressing the mark on its side (1) and
pulling in the direction of the arrow (2).
2. Insert the Tape Cassette following the
drawing marked inside the case.
Confirm that the tip of the tape is
pointed at the Tape Exit Slot.
3. Press the Tape Cassette into the label
printer until it snaps into place.
NOTE
• After the tape passes under the Tape
Guide, pull the tip to remove any slack
in the tape.
• Make sure the tape is not caught in
the unit when inserting or removing
the Tape Cassette.
4. Insert the two hooks at the rear of the
Cassette Cover into the slots on the
label printer (3). Push the Cassette
Cover closed (4), making sure it locks
into place.
).
2
End of Tape
Tape Guide
3
Cassette Cover
1
Print Head
4