AEG L 61470 BI Manual del usuario - Página 22
Navegue en línea o descargue pdf Manual del usuario para Lavadora AEG L 61470 BI. AEG L 61470 BI 36 páginas. Washing machines
También para AEG L 61470 BI: Manual del usuario (36 páginas)
![AEG L 61470 BI Manual del usuario](/uploads/products/server2/241689/241689.jpg)
22
www.aeg.com
0° C, remove the remaining water from
the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Place the end of the emergency
emptying hose and that of the inlet
hose in a bowl placed on the floor
and let water flow out of the hoses.
4. Select the draining programme and
let it operate until the end of the
cycle.
5. Turn the programme dial to Off to
disconnect the appliance from the
power supply.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 Introduction
The appliance does not start or it stops
during operation.
First try to find a solution to the problem
(refer to the table). If the problem
persists, contact the Authorised Service
Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
•
- The appliance does not fill with
water properly. Start the appliance
again by pressing Start/Pause button.
After 10 seconds the door will be
unlocked.
•
- The appliance does not drain
the water.
13.2 Possible failures
Problem
The programme does
not start.
6. Screw the water inlet hose back on
•
•
•
•
Possible solution
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that the appliance door is closed.
• Make sure that there is not a damaged fuse in the fuse box.
• Make sure that the Start/Pause has been pressed.
• Deactivate the Child Lock function if it is on (if available).
and re-fit the emergency emptying
hose after having put the cap on
again.
WARNING!
Make sure that the
temperature is higher than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
- The appliance door is open or
not closed correctly. Please check the
door!
- The mains supply is unstable.
Wait until the mains supply is stable.
- No communication between
electronic elements of the appliance.
Switch off and switch on again. The
programme was not finished properly
or the appliance stopped too early. If
the alarm code appears again,
contact the Authorised Service
Centre.
- The anti-flood device is on.
Disconnect the appliance and close
the water tap. Contact the Authorised
Service Centre.
WARNING!
Deactivate the appliance
before you do the checks.