AEG L 63470 FL Manual del usuario - Página 22

Navegue en línea o descargue pdf Manual del usuario para Lavadora AEG L 63470 FL. AEG L 63470 FL 48 páginas.

Imprimir página

www.aeg.com

Problem

There is water on the

floor.

You cannot open the ap-

pliance door.

The appliance makes an

unusual noise.

The cycle is shorter than

the time displayed.

The cycle is longer than

the time displayed.

The washing results are

not satisfactory.

You cannot set an op-

tion.

After the check, activate the appliance. The programme continues from the point of

interruption.

If the problem occurs again, contact the Authorised Service Centre.

If the display shows other alarm codes. Deactivate and activate the appliance. If the

problem continues, contact the Authorised Service Centre.

Possible solution

Make sure that the drain filter is not clogged. Clean the filter, if

necessary. Refer to 'Care and cleaning'.

Adjust manually the items in the tub and start the spin phase

again. This problem may be caused by balance problems.

Make sure that the couplings of the water hoses are tight and

there is not water leakages.

Make sure that the drain hose have no damages.

Make sure you use the correct detergent and the correct quan-

tity of it.

Make sure that the washing programme is finished.

Set the drain or the spin programme if there is water in the

drum.

Make sure the levelling of the appliance is correct. Refer to 'In-

stallation'.

Make sure that the packaging and/or the transit bolts are re-

moved. Refer to 'Installation'.

Add more laundry in the drum. The load may be too small.

The appliance calculates a new time according to the laundry

load. See the 'Consumption Values' chapter.

An unbalanced laundry load increases the duration time. This

is a normal behaviour of the appliance.

Increase the detergent quantity or use a different detergent.

Use special products to remove the stubborn stains before you

wash the laundry.

Make sure that you set the correct temperature.

Decrease the laundry load.

Make sure that you press only the wanted touch button(s).