Fujitsu BS2000 SE Series Manual de instrucciones - Página 11
Navegue en línea o descargue pdf Manual de instrucciones para Servidor Fujitsu BS2000 SE Series. Fujitsu BS2000 SE Series 22 páginas. Server unit x86
También para Fujitsu BS2000 SE Series: Manual rápido (43 páginas), Manual (42 páginas), Manual de instrucciones (20 páginas), Manual de instrucciones (25 páginas)
Imprimir página
2.2.1 Controls
Control
Meaning
ID
Identification (ID) button
The ID indicators light up (blue) on the front and on the rear of the Server Unit when the ID button is
pressed. The two ID indicators are synchronized.
On/Off switch
When the Server Unit is switched off, it is switched on again by pressing the On/Off switch once.
When the Server Unit is in operation, it is switched off by pressing the On/Off switch once (this takes a
little time).
Normally the system may only be switched on or off by Customer Support. The customer should only
perform an "emergency power off", see SE x86 "Switching off in an emergency" in the Basic Operating
Manual [ ].
1
For information on switching on and starting the SE300 and on switching it off and shutting it down,
see "Switching the SE x86 on and off" in the Basic Operating Manual [ ].
!
CAUTION!
Loss of data
When the On/Off switch is pressed and held down for several seconds, Server Unit
operation is terminated ungracefully and abruptly. Notify Customer Support.
i
The On/Off switch does not disconnect the server from the voltage grid. To disconnect from
the voltage grid completely, remove the power plug(s).
RST or
Reset button
RESET
Pressing the Reset button reboots the Server Unit.
!
CAUTION!
Possible loss of data!
NMI button
NMI
!
CAUTION!
Do not press! Possible loss of data! The NMI button may only be used by Customer Support.
1
11