Fujitsu PRIMERGY CX122 S1 Manual de instrucciones - Página 44

Navegue en línea o descargue pdf Manual de instrucciones para Servidor Fujitsu PRIMERGY CX122 S1. Fujitsu PRIMERGY CX122 S1 50 páginas.

Switching the server on and off

5.3

Switching the server on and off

CAUTION!

The On/Off button does not isolate the device from the mains voltage. To

disconnect it completely from the PRIMERGY CX1000 power distribution

unit, loosen the two knurled screws on the server front and slide the

server out of the rack about 10 centimeters.

5.3.1

The Power-on indicator (item 5 in figure

Starting up the server for the first time

When starting up a PRIMERGY CX122 S1 server node for the first time, there

are several installation options, depending on the system configuration. For

further information, please refer to

System already installed

– Hard disk drives installed - Local boot

Ê Press the On/Off button (item 5 in figure

The server is switched on, performs a system test and boots the

operating system.

– No hard disk drives installed - iSCSI boot

iSCSI (Internet SCSI) is a protocol for linking servers and data storage

facilities, similar to the Fibre Channel Protocol (FCP). iSCSI means "SCSI

over Internet Protocol". iSCSI boot allows a server to be booted remotely

from a drive in an iSCSI-based Storage Area Network (SAN).

For further instructions, please refer to the "iSCSI Boot for PRIMERGY

Servers with Intel Network Controllers" installation and configuration guide,

available from the ServerView Suite DVD 2 or at http://manuals.ts.fujitsu.com.

10 on page

section "Configuring the server" on page

10 on page

Operating Manual

41) lights up green.

41).

45.

CX122 S1