Fujitsu Primergy RX300 S3 Manual de inicio - Página 2

Navegue en línea o descargue pdf Manual de inicio para Servidor Fujitsu Primergy RX300 S3. Fujitsu Primergy RX300 S3 8 páginas. Dual- or quad-core intel xeon server
También para Fujitsu Primergy RX300 S3: Especificaciones (2 páginas)

Imprimir página

Fujitsu Primergy RX300 S3 Manual de inicio

Conditions

n Restriction of installation features

When installing this server, avoid the following areas.

��

��℃��℃

��

- In dusty areas, dust will stick to the front and backside of the server for a short period of time. Since it causes

failure, changing the installation place is recommended.

- When Power Supply Conversion kit is used, Noise level of this server is measured at 55dB. It is recommended

to place the server in an exclusive room. Use the server with care if it is placed in an office.

■ Install the server into the rack

- Be sure to secure the rack with stabilizers to prevent the

device from tipping over. For details on installing the rack,

refer to the "Installation Guide for the RACK" and the

manual provided with the rack.

- The weight of the server exceeds 18kg. When you carry

the server, have a right and left side and the bottom of

the body by two or more people. Do not have a hand on

the following part because this part is transformed easily.

Open both the front and rear doors of

the rack.

Check where to attach the slide rail

and rack nuts.

Attach the slide rail to the front and rear brackets.

Attach the rack nuts to the front brackets.

��

Remove the inner rail from the slide rail

��

Attach the inner rail to the server.

Set the screws on the server side in the holes of the rail

(1), and slide the rail forward to fix it (2).

��

�

Attach the slide rail assemblies and in-

sert the rack nuts into the rack holes.

Insert the projections from the back side in the rack,

and attach the slide rails with the washers.Insert

latches of the rack nuts from inside of the rack

bracket.

��

�