Fujitsu PRIMERGY RX600 S3 Manual de inicio - Página 2

Navegue en línea o descargue pdf Manual de inicio para Servidor Fujitsu PRIMERGY RX600 S3. Fujitsu PRIMERGY RX600 S3 8 páginas. Sas model

Imprimir página

Fujitsu PRIMERGY RX600 S3 Manual de inicio

Conditions

n Restrictions of installation locations

Avoid the following areas:

��

��℃��℃

��

- In dusty areas, dust will stick to the front and backside of the server for a short period of time. Since it causes

failure, changing the installation place is recommended.

- Noise level of this server is measured at 52.4 dB. It is recommended to place the server in an exclusive room.

Use the server with care if it is placed in an office.

n When installing the server in the rack

- Be sure to secure rack with stabilizers to prevent the device tipping over. For details on installing the rack, refer

to the "Installation Guide for the RACK" and the manual provided with the rack.

- The weight of the server exceeds 36 kg. When you carry the server, have the right and left sides and the bot-

tom of the server by three or more people.

- There are slide rails for the right and the left. Refer to "Contents List" and attach them correctly.

Open both the front and rear doors of

the rack.

Confirm that clamps of the slide rail

which are shown in the figure below

are set in parallel for the rail.

When the clamps are vertical to the rail, the server

cannot be installed into the rack.

Bring down the clamps in the direction of the ar-

row, and set them in parallel.

Decide where to attach the slide rail.

Choose the height at which - to place the server in

the rack by aligning the base of the server with one

of the narrower spaces - in the rack bracket.

��

Attach rack nuts.

Use 4U per device. Insert the rack nuts in the rack's

11th hole (counting up from the bracket base).

��

Secure the slide rail to the rack.

Follow the procedures below to secure it to the rack

brackets.

1. Insert the protrusions in the rack's 4th and 7th

holes (counting up from the bracket base).

2. Push in the lock in the rack's 9th hole.

3. Confirm that you can see the screw hole at

the rack's 6th hole, and secure it with the

supplied screw.

��

For the rear side, slide the rail to adjust length and

secure to the rack in the same way for the front side.

��