Brother MFC 1780 Manual de configuración rápida - Página 6

Navegue en línea o descargue pdf Manual de configuración rápida para Fax Brother MFC 1780. Brother MFC 1780 24 páginas. Quick setup guide - english

PC Configuration Requirements

Your PC must meet or exceed the following minimum system configuration

requirements for you to install and use Multi-Function Link

CPU

80486/66 or higher

RAM

8MB or greater for Windows

recommended)

16MB or greater for Windows NT

Version 4.0 (32MB recommended)

Hard Disk Drive

50MB

Operating System Windows

Port

Available Serial port

CD-ROM Drive

Follow the instructions below to hook up the Multi-Function Link

Position your Brother machine near your personal computer CPU

(maximum distance of approximately 5–6 feet (1.5–1.8 m)).

Make sure the power to the PC is switched off and the Brother machine

is unplugged.

Connect the RJ-8 connector of the Multi-Function Link

back of your Brother machine in the jack labeled PC I/F.

Connect the 25-pin female RS-232 connector of the Multi-Function

Link

Cable to your PC in the available male serial communications

port. Use the 9-pin adapter if your PC requires it. (See your PC

owner's manual for the correct interface port for connection.) NOTE:

If your PC is an IBM Aptiva, an MWAVE card is using COM1. You

must connect the Multi-Function Link

serial port that is available.

3.1x

95/98 (16MB

3.1x, 95/98 or NT

Workstation Version 4.0

Cable to another COM

Workstation

Cable:

Cable to the

or or