Fujitsu SPARC Enterprise M9000 Notas sobre el producto - Página 14
Navegue en línea o descargue pdf Notas sobre el producto para Servidor Fujitsu SPARC Enterprise M9000. Fujitsu SPARC Enterprise M9000 44 páginas. For xcp version 1041
También para Fujitsu SPARC Enterprise M9000: Manual de introducción (4 páginas), Características Manual (30 páginas), Manual complementario (36 páginas)
Imprimir página
Known Issues
This section describes known issues in this release.
General Functionality Issues and Limitations
Because the term, admin, will be reserved for the system use in next version of
■
XCP, please avoid using it to user account name. If you use the term, admin, to
user account name, you have to delete it before upgrading the XCP.
Dynamic Reconfiguration (DR) is not recommended in cases below, due to the
■
following restrictions on the DR addboard(8), deleteboard(8), and
moveboard(8) commands. Please contact your Sales representative or Technical
Support for additional information and software support.
■
Caution – Use of DR in an unsupported configuration might result in a domain
panic or might hang the system.
Domains using the ZFS file system can not use Reconfiguration.
■
PCI Hotplug feature is not available for this release.
■
Please contact your sales representative or technical support for additional
information and software support.
The maximum number of IOUA (Base I/O Card) cards per domain is limited to
■
six cards.
On the SPARC Enterprise M8000/M9000 servers, the dual eXtended System
■
Control Facility (XSCF) unit (Service Processor) is not supported.
Do not use the internal CD-RW/DVD-RW drive unit and the TAPE drive unit at
■
the same time.
While Solaris is running, do not use the cfgadm(1M) command to add/remove
■
the CD-RW/DVD-RW drive unit and the TAPE drive unit to/from a domain. To
use the CD-RW/DVD-RW drive unit or the TAPE drive unit, use the
cfgdevice(8) command to attach/remove it to/from the domain before booting
the OS.
The XSCF web browser interface, also known as the browser user interface (BUI),
■
has limited availability in this release. It can be used for importing the XSCF
firmware and supports the snapshot(8) command Full log set collection
function. Use the command-line interface (CLI) instead on the Service Processor
and the domains for other activities.
Power off all domains before upgrading the XCP firmware.
■
4
SPARC Enterprise M8000/M9000 Servers Product Notes for XCP Version 1041 • October 2007
The target board (SB/XSB) with optional I/O cards because of some restrictions
on specific cards.