Fujitsu fi-5220C Primeros pasos - Página 24

Navegue en línea o descargue pdf Primeros pasos para Escáner Fujitsu fi-5220C. Fujitsu fi-5220C 28 páginas. Flatbed scanner
También para Fujitsu fi-5220C: Manual de procedimientos de instalación (7 páginas), Manual de procedimientos de instalación (9 páginas), Procedimientos de instalación (3 páginas), Especificaciones (2 páginas), Manual de introducción (29 páginas), Manual de instrucciones (13 páginas), Instrucciones de limpieza (2 páginas), Instrucciones de limpieza (2 páginas)

Imprimir página
Fujitsu fi-5220C Primeros pasos
Symptom
Paper is not fed (pick error
occurs frequently, or docu-
ment stops midway).
The generated images are
elongated.
There is a shadow on the
leading edge of the gener-
ated image.
AP-2
Check this item
Do the documents satisfy the "Docu-
ment Quality" and the "Multi feed
Detection Conditions" in the chapter 6
of the fi-5530C Operator's Guide?
Is the Pick roller dirty?
Is the Pick roller worn out?
Is there any dirt or dust in the document
feed path?
Are the Feed rollers dirty?
Have you adjusted the scan scale?
Are the Feed rollers dirty?
Have you adjusted the offset (the scan-
ning starting position)?
Remedy
Use the documents that satisfy the "Document
Quality" and the "Multi feed Detection Condi-
tions" in the chapter 6 of the fi-5530C Operator's
Guide.
Clean the Pick roller. Refer to Operator's Guide in
"3.3. Cleaning the ADF".
Change the Pick roller. Refer to Operator's Guide
in "4.3. Replacing the Pick Roller".
Remove any dirt or dust from the document feed
path.
Clean the Feed rollers. Refer to Operator's Guide
in "3.3. Cleaning the ADF".
For Windows 98, Windows Me, Windows 2000,
WindowsXP, select "Scanners and Cameras" in
the control panel, then click the [Device Set] tab
to adjust scale.
For Windows 95, Windows NT 4.0, right click the
Scanner Control Center in the task tray, select
[Options] and adjust the scan scale.
Clean the Feed rollers. Refer to Operator's Guide
in "3.3. Cleaning the ADF".
For Windows 98, Windows Me, Windows 2000,
WindowsXP, adjust the [Sub-scan Setting] on
[Scanners and Cameras] in the control panel.
For Windows 95, Windows NT 4.0, right click the
Scanner Control Center, select [Options]-[Sub-
scan Setting] and adjust the offset.