Fujitsu fi-5650C Procedimientos de instalación - Página 3

Navegue en línea o descargue pdf Procedimientos de instalación para Escáner Fujitsu fi-5650C. Fujitsu fi-5650C 3 páginas. Image scanner
También para Fujitsu fi-5650C: Manual de procedimientos de instalación (7 páginas), Manual de procedimientos de instalación (9 páginas), Especificaciones (2 páginas), Folleto y especificaciones (2 páginas), Manual de introducción (40 páginas), Manual de instrucciones (11 páginas), Instrucciones de limpieza y sustitución de consumibles (19 páginas), Instrucciones de limpieza (2 páginas), Limpieza y mantenimiento (39 páginas)

Fujitsu fi-5650C Procedimientos de instalación
Fujitsu SCSI (650) VRS
Step D: Connecting the Scanner.
Warning! Before proceeding ensure that the power is off when connecting or
disconnecting the SCSI cable to the scanner or workstation. Failure to follow the
procedure above could result in damage to the SCSI card, scanner, and/or your system.
Termination and the SCSI ID's for the scanners are handled automatically.
Connect the SCSI cable to the Kofax controller and to the Wide SCSI (68-pin)
port on the scanner. Ensure all connections are securely fastened.
Connect the power cord to the scanner and a wall outlet. Turn on the scanner
first and when it reports ready boot up your PC. Complete the new hardware
found wizard and go to the next step.
Step E: Scanning with VCDEMO32P.
1. Go to Start, Programs, Kofax VRS or Kofax Image Controls, and select
VCDEMO32P.EXE.
2. Next go to Source, Scanner, and click on the drop down arrow; then
select your scanner model. I.E. Fujitsu fi-4860C with VRS with AIPE.
Wait a few seconds for the Kofax engine to load, and then place your
documents in the scanner.
3. Now go to Source, Properties and select your scanning parameters (i.e.
scan source - Flatbed or ADF, resolution, paper size).
4. You may also access the VRS configuration settings at this time by clicking
on Advance Properties. The AIPE functions are access via the Imaging
menu.
5. Afterwards go to Source, and click on Process Image for single page scans
or Process Batch for multi-page batch scans.
Congratulations! You have successfully completed and tested your VRS scanner
installation.
Step F: Installing third party software applications.
After you have successfully installed all the Fujitsu software and hardware, then it is time
to install any additional third party scanning software that you wish to use. Please follow
the software manufacturer's instructions for installation. Remember when installing any
software that contains Kofax's Image Controls pay close attention to the individual
runtimes. It is strongly recommended that you install the oldest/lower runtime
application first.
Rev052206A
Scanner Installation Procedures
Windows ME\2000\XP
Page 3 of 3