Fujitsu PA03338-B005 - FI-5750C Image Scanner Manual de introducción - Página 19

Navegue en línea o descargue pdf Manual de introducción para Escáner Fujitsu PA03338-B005 - FI-5750C Image Scanner. Fujitsu PA03338-B005 - FI-5750C Image Scanner 42 páginas. Image scanner

Imprimir página

Windows XP, connect the scanner to your PC

with either the USB or the SCSI interface

cable.

Do not connect both the USB interface

cable and the SCSI cable at the same

ATTENTION

time. It is not possible to use the USB

interface with Windows 95 and/or

WindowsNT 4.0.

Connecting the USB Cable

Please connect a USB cable to the

Scanner.

Connect the USB interface cable to the

USB interface connector of the scanner.

Please connect the other end of the

cable to your PC.

Turn ON the scanner.

Turn ON your PC.

Use the USB interface cable provided as

an accessory for the scanner. Operation

ATTENTION

with a commercially available USB cable

is not guaranteed. When connecting to a

USB hub, be sure to connect to the hub

nearest your computer (first stage). If you

connect it to a USB hub from the second

stage onwards the scanner may not

operate correctly.

Connecting the SCSI

interface cable

When using the scanner with the SCSI inter-

face, you need to purchase a commercially

available SCSI cable and a SCSI card.

•

SCSI cable

The SCSI has to fit to a 50 Pin half pitch connector

and the SCSI card connector of your PC.

•

SCSI card

Use the recommended SCSI card noted on the fol-

lowing website:

http://imagescanner.fujitsu.com/

When connecting the SCSI interface

cable, be sure to first connect the SCSI

ATTENTION

interface cable then turn on the scanner

and your PC. Connect the scanner so

that it is the terminated device on the

SCSI daisy chain.

Connect the SCSI cable to the scanner.

Connect the SCSI cable to the SCSI

interface connector and make sure it is

firmly connected.

Connect the other end of the cable to

your PC.

For setting the SCSI ID of the scanner,

please refer to the following section.

HINT

Setting the SCSI ID

The factory default setting for SCSI ID is "ID 5". If the

SCSI ID of another device has already been set to the

same ID, change either the scanner's SCSI ID or that of

2-3