1. Preparation
This chapter describes necessary preparations before using
ScanSnap.
Do not connect the scanner to your personal
ATTENTION
computer before installing "ScanSnap Manager."
If you connect the scanner before installing
ScanSnap Manager, it will not operate correctly.
Refer to Chapter 2 for details on the installation of
ScanSnap Manager.
1.1. Checking the Contents of the
Package
When you unpack the scanner package, make sure that all
parts are included.
Refer to the packing list included in the scanner package
for contents.
1.2. Name and Function of Parts
This section describes the name and function of parts.
Front Side
Paper chute
Open the paper chute to use
the scanner.
Opening the paper chute
turns ON the scanner.
Paper chute
Open the paper chute and load
documents onto it for scanning
documents.
Side guide
Adjust these guides to fit the
width of the paper, so that the
paper does not skew.
Cover open lever
Pull this lever to open the ADF.
ADF
(ADF: Automatic Document
Feeder)
Stacker
Extend this part to use the stacker
as shown in the figure.
Sheets of paper are ejected from the ADF onto the stacker.
* You can also use the scanner without the Stacker.
Buttons
Back Side
USB connector
Seal: After installing
ScanSnap Manager onto
your computer, remove
this seal to connect the
scanner to the PC.
HINT
ATTENTION
Buttons
ScanSnap S510M for Mac Getting Started | 5
[SCAN] button
Start scanning.
[POWER] button
Hold down 1 sec. to turn
on/off the power supply.
Power lamp
Indicate the scanner status.
Blue (Solid):
Blue (Blinking): Scanning
Orange:
Light out:
AC adapter connector
Security cable slot
Plug a commercially
available security cable
into this slot (anti-theft).
For the Document Specifications, refer to the
"ScanSnap S510M for Mac Operator's Guide"
stored in ScanSnap Setup CD-ROM.
The scanner turns on/off automatically when you
open/close the Paper chute.
To turn off the scanner with the cover opened,
press the [POWER] button.
Ready
Error
Power off
Imprimir página