For Wireless Network Users
For wireless network interface users
11
Before you begin
Although your Brother machine can be used in both a wired and wireless network, only one of the connection
methods can be used at a time.
NOTE
If you have previously configured the wireless settings of the machine you must reset the network settings
before you can configure the wireless settings again.
On your machine, press Settings.
Press s or t to display Network. Press Network.
Press s or t to display Network Reset. Press Network Reset.
Press Yes to accept. Hold down Yes for 2 seconds to confirm.
NOTE
To set up your machine in Ad-hoc mode (connected to a wireless-capable computer without an access
point/router) you can find instructions in the Network User's Guide on the CD-ROM.
You can view the Network User's Guide by following the instructions below.
1 Turn on your computer. Insert the CD-ROM into your CD-ROM drive.
®
For Windows
:
2 Choose your model and the language. The CD-ROM top menu will appear.
3 Click User's Guides, and then click PDF documents.
4 Click Network User's Guide.
For Macintosh:
2 Double-click User's Guides. Choose your model and the language.
3 Click User's Guides, and then click Network User's Guide.
12
Choose your wireless setup method
The following instructions offer three methods for setting up your Brother machine on a wireless network. Choose
the method you prefer for your environment.
a
Setup using the installation CD-ROM and a USB cable (Windows
You need to temporarily use a USB cable during configuration (cable not included).
It is recommended that you use a computer wirelessly connected to your network for this method.
If you are using Windows
point/router by network cable, you need to know your wireless settings. Please write down your
wireless network settings in the area on page 17.
Now go to
16
®
XP, or currently using a computer connected to an access
®
and Macintosh)
page 18
Imprimir página