Brother HL-3075CW Manual de configuración rápida - Página 27

Navegue en línea o descargue pdf Manual de configuración rápida para Servidor de impresión Brother HL-3075CW. Brother HL-3075CW 45 páginas. Digital color printer
También para Brother HL-3075CW: Manual de configuración rápida (29 páginas), Especificaciones técnicas (2 páginas)

Imprimir página

For Wireless Network Users

One push configuration using Wi-Fi Protected Setup or AOSS™

Configure the wireless

settings

Confirm your WLAN access point/router has

the Wi-Fi Protected Setup or AOSS™ symbol

as shown below.

Place the Brother machine within range of your

Wi-Fi Protected Setup or AOSS™ access

point/router. The range may differ depending

on your environment. Refer to the instructions

provided with your access point/router.

Press any of the Menu buttons (+, -, OK or

Back) of the control panel on your machine.

Press + or - to choose Network, WLAN or

SES/WPS/AOSS. And then, press OK.

The machine searches for an access point that

supports Wi-Fi Protected Setup or AOSS™ for

2 minutes.

Push the Wi-Fi Protected Setup or AOSS™

button on your WLAN access point/router. See

the user's guide for your WLAN access

point/router for instructions.

This feature will automatically detect which

mode (Wi-Fi Protected Setup or AOSS™) your

access point/router uses to configure your

machine.

Note

If your wireless access point/router supports

Wi-Fi Protected Setup (PIN Method) and you want

to configure your machine using the PIN

(Personal Identification Number) Method, see

How to configure your wireless machine, using

the PIN Method of Wi-Fi Protected Setup in the

Network User's Guide.

If the LCD shows Connected, the printer has

successfully connected to your access

point/router. You can now use your printer in a

wireless network.

If the LCD shows Connection Error, a

session overlap has been detected. The printer

has detected more than one access

point/router on your network with the Wi-Fi

Protected Setup mode or AOSS™ mode

enabled. Make sure that only one access

point/router has the Wi-Fi Protected Setup

mode or the AOSS™ mode enabled and try

starting from c again.

If the LCD shows No Access Point, the

printer has not detected your access

point/router on your network with the Wi-Fi

Protected Setup mode or AOSS™ mode

enabled. Move the printer closer to your access

point/router and try starting from c again.

If the LCD shows Connection Fail, the

printer has not successfully connected to your

access point/router. Try starting from c again.

If the same message is indicated again, reset

the print server back to its factory default

settings and try again. For resetting, see Reset

the network settings to the factory

default on page 32.

Wireless setup is now complete. A four

level indicator at the right of your

machine's LCD will show the wireless

signal strength of your access

point/router.

To install the printer driver, continue to;

For Windows

Users:

Now go to

step 12 on page 28

For Macintosh Users:

Now go to

step 12 on page 30