Fujitsu ETERNUS DX Disk Manual de configuración - Página 12

Navegue en línea o descargue pdf Manual de configuración para Almacenamiento Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 32 páginas. Server connection, fcoe for linux driver settings for converged network adapter cards
También para Fujitsu ETERNUS DX Disk: Manual del usuario (35 páginas), Manual del usuario (42 páginas), Manual de configuración (28 páginas), Manual de configuración (44 páginas), Manual de configuración (28 páginas), Manual de configuración (29 páginas), Manual de configuración (25 páginas), Manual de configuración (35 páginas), Manual de configuración (31 páginas), Manual de configuración (43 páginas), Manual de configuración (21 páginas), Manual de configuración (24 páginas)

Chapter 3

Notes

Note the following issues when connecting the ETERNUS DX/AF to a server.

3.1

To ensure reliable access to ETERNUS DX/AF storage systems, multipath configuration is recommended.

•

Setting up multiple access paths between the server and the ETERNUS DX/AF storage systems, then using

•

the XenServer multipath, provides improved access redundancy.

Enable the virtualization support functions (Intel VT or AMD-V) of the server before installing XenServer.

•

For details on the settings, refer to the relevant manual of the server to be used.

Install XenServer when the ETERNUS DX/AF is not connected to the server.

•

The ETERNUS Multipath Driver does not need to be installed on the XenServer Virtual Machine. The Xen-

•

Server multipath provides path redundancy.

When multiple paths are used, a multipath driver must be set. If a multipath driver is not set, the XenServ-

•

er multipath does not perform proper load balancing for the ETERNUS DX/AF.

Before setting a multipath configuration, create Storage Repositories for all the LUNs that exist in the

•

ETERNUS DX/AF.

3.2

If a path error occurs in a multipath configuration using XenServer, the status of the failed multipath may

•

not be displayed. The status is displayed again when the failed path recovers.

When XenServer is managed and operated with XenCenter, multipath errors may not be detected properly

•

by XenCenter. When checking multipath status, also check the status on the XenServer host side.

3.3

Host Response must be set before the ETERNUS DX/AF is connected to the XenServer host.

•

Even if the Eco-mode of the ETERNUS DX/AF is enabled for a multipath configuration with XenServer, disk

motors may not stop according to the Eco-mode settings.

FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Citrix

XenServer

P3AM-4572-19ENZ0