Fujitsu ETERNUS DX Disk Manual de configuración - Página 27

Navegue en línea o descargue pdf Manual de configuración para Almacenamiento Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 35 páginas. Server connection, fcoe for linux driver settings for converged network adapter cards
También para Fujitsu ETERNUS DX Disk: Manual del usuario (35 páginas), Manual del usuario (42 páginas), Manual de configuración (28 páginas), Manual de configuración (44 páginas), Manual de configuración (28 páginas), Manual de configuración (29 páginas), Manual de configuración (25 páginas), Manual de configuración (32 páginas), Manual de configuración (31 páginas), Manual de configuración (43 páginas), Manual de configuración (21 páginas), Manual de configuración (24 páginas)

Imprimir página

Fujitsu ETERNUS DX Disk Manual de configuración

Chapter 2

Setup Procedure for QLogic Converged Network Adapter Cards

2.2

Setting Up the Converged Network Adapter Cards

Check the values for each parameter.

Selectable Boot:

(Primary) Boot Port Name, Lun:

Parameter

Selectable Boot

Boot Port Name, Lun

Return to the [Configuration Settings] menu by pressing the [Esc] key.

Press the [Esc] key twice to return to the [Fast!UTIL Options] menu.

If the settings were changed, save the settings using [Save xxxxxx].

When two or more Converged Network Adapter cards are installed in the server, select the second or

later Converged Network Adapter card using the following steps, and set the selected card.

(1)

Select [Select Host Adapter] from the [Fast!UTIL Options] menu and press the [Enter] key.

(2)

Select the Converged Network Adapter card to be set (BIOS setting).

(3)

The [Fast!UTIL Options] menu appears. Then perform

Select [Exit Fast!UTIL] and press the [Enter] key.

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware

Selectable Boot Settings

Boot Port Name, Lun:

Press "C" to clear a Boot Port Name entry

Setting value

Enabled or Disabled

ETERNUS DX port WWN, LUN#

or 0000000000000000, 0

Fast!UTIL Options

Configuration Settings

Scan Fibre Devices

Fibre Disk Utility

Loopback Data Test

Select Host Adapter

Exit Fast!UTIL

Select Host Adapter

Adapter Type

Address

Slot Bus Device Function

QLE8142

5800

QLE8142

5C00

Enabled

500000E0D4010590,

0000000000000000,

Remarks

•

Step 1

through

Set [Enabled] for SAN Boot.

Set [Disabled] for non SAN Boot.

The boot path (ETERNUS DX port WWN)

and boot LUN# for SAN Boot are separated

by a comma.

"0000000000000000, 0" for non SAN

Boot.

Step

ESX

P3AM-4772-11ENZ0