AEG A51900GSW0 Manual del usuario - Página 29
Navegue en línea o descargue pdf Manual del usuario para Frigorífico AEG A51900GSW0. AEG A51900GSW0 48 páginas.
Imprimir páginaDo a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cab-
inet.
• The door opens and closes correctly.
9. NOISES
There are some sounds during normal
running (compressor, refrigerant circula-
tion).
G
180°
Slide the door off the pin (G). Unscrew
the pin (G) and install it on the opposite
side.
Unscrew the pivot pin (Z) of the hinge (E)
and the rear screw (Y) with a spanner of
10 mm and remove the closing device
(M). Take from the accessory bag the
lower closing device left and install it on
the opposite side of the same hinge by
screwing again the rear screw.
Unscrew the upper closing device (N)
from the bottom of the door. Take from
the accessory bag the upper closing de-
vice left and install it on the opposite
side of the bottom of the door by screw-
ing again the screw.
Install the door.
Install the bottom hinge (E) on the oppo-
site side, using the three screws previ-
ously removed inserting the hinge gas-
ket (X).
Remove the blanking cover (F) from the
ventilation grille (D) by pushing it in the
direction of the arrow and install it on
the opposite side.
Install the ventilation grille (D), clipping it
into place.
Unscrew the handle. Remove the plug
with a punch. Install the handle and the
plug on opposite side. Take from the ac-
cessory bag the two plugs and cover the
holes left open after having removed the
handle.
Make sure that the front board of the
door is parallel to the front board of the
top.
Reposition, level the appliance, wait for
at least four hours and then connect it to
the power socket.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly
to the cabinet. In that case, wait for the
natural fitting of the gasket.
ENGLISH
29