AEG OKO-SANTO 2842-6 i Instrucciones de uso e instalación - Página 20
Navegue en línea o descargue pdf Instrucciones de uso e instalación para Frigorífico AEG OKO-SANTO 2842-6 i. AEG OKO-SANTO 2842-6 i 28 páginas. Integrating fridge freezer
También para AEG OKO-SANTO 2842-6 i: Instrucciones de uso e instalación (14 páginas)
Imprimir página
Installation Location
The appliance should be set up in a well ventilated, dry room.
Energy use is affected by the ambient temperature. The appliance
should therefore
Ð not be exposed to direct sunlight;
Ð not be installed next to radiators, or other sources of continuous heat;
Ð only be installed at a location whose ambient temperature corre-
sponds to the climate classification, for which the appliance is desi-
gned.
The climate classification can be found on the serial plate, which is
located at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for
each climate classification:
Climate classification
Your appliance needs air
For safety reasons, minimum venti-
lation must be as shown Fig.
Attention: keep ventilation ope-
nings clear of obstruction;
Reversing the door
The side at which the door opens can be changed from the right side
(factory adjustment) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the
appliance may not be connected to the mains. Remove plug from the
mains beforehand.
20
SN
N
for an ambient temperature of
+10 to +32 ¡C
+16 to +32 ¡C
50 mm
D567
min.
2
cm
200