Fujitsu FPCPR44AP Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Tableta Fujitsu FPCPR44AP. Fujitsu FPCPR44AP 10 páginas. Tablet pc tablet dock

Imprimir página

S t y l i s t i c S T S e r i e s T a b l e t D o c k

Prolonged use of the media drive, such

as watching a DVD movie, will signifi-

cantly reduce your battery life if no other

power source is attached. Be sure to

attach a power adapter when using the

Tablet Dock for prolonged tasks.

You should periodically check the Fujitsu

Web site at us.fujitsu.com/computers for

updated drivers.

All Fujitsu DVD players are set to play

DVD titles with region code number 1

(North American market). The region

number is a regional restriction code

defined by the DVD Forum acting on

requirements of Hollywood. Different

region codes are recorded on video DVD

titles for publication in different areas of

the world. If the regional code of the

DVD player does not match the codes on

the titles, then playback is impossible.

You can change the region code on the

DVD player using the Properties menu of

the DVD software, but you can only

change the region code up to four times.

After the 4th change, the last region

code entered becomes permanent, and

cannot be changed.

LOADING MEDIA

(Refer to Figure 8 for the following steps)

To load a disc into your media player drive, follow these

steps:

1. Push and release the eject button on the front of the

drive to open the holder tray. The tray will come out

of the system a short distance.

2. Gently pull the tray out until a media disc can easily

be placed in the tray

There may be a protective sheet in the tray

from when it was shipped; make sure it is

removed before operating the drive.

3. Place the media into the tray, label side up, with the

hole in the center of the disc. Snap the disc onto the

raised circle in the center of the tray.

4. Push the holder tray back in until you hear a click.

REMOVING MEDIA

(Refer to Figure 8 for the following steps)

1. Push and release the eject button on the front of the

media player drive. This will stop the drive and the

holder tray will come out of the system a short

distance.

2. Gently pull the tray out until the disc can easily be

removed from the tray.

3. Remove the media disc from the holder tray.

4. Push the holder tray back in until you hear a click.

Figure 8. Loading/Ejecting Media