Fujitsu LIFEBOOK Notebook Manual del usuario - Página 43
Navegue en línea o descargue pdf Manual del usuario para Tableta Fujitsu LIFEBOOK Notebook. Fujitsu LIFEBOOK Notebook 44 páginas. Lifebook notebook
También para Fujitsu LIFEBOOK Notebook: Manual del usuario (39 páginas), Manuales de limpieza general (3 páginas)
Imprimir página
Problem
Video Problems
The built-in
display is blank
when you turn
on your LifeBook
notebook.
The LifeBook
notebook turned
on with a series of
beeps and your
built-in display is
blank.
The display goes
blank by itself after
you have been
using it.
Possible Cause
The notebook is set for
an external monitor only.
The angle of the display
and the brightness
settings are not dequate
for your lighting
conditions.
The power management
time-outs may be set for
very short intervals and
you failed to notice the
display come on and go
off again.
Power On Self Test
(POST) has detected
a failure which does
not allow the display to
operate.
The notebook has gone
into Video Timeout,
Standby mode, Suspend
mode or Save-to-Disk
mode because you have
not used it for a period
of time.
The power management
time-outs may be set for
very short intervals and
you failed to notice the
display come on and go
off again.
Something is pushing on
the Closed Cover switch.
Troubleshooting
Possible Solution
Pressing [F10] while holding down the [Fn]
key allows you to change your selection of
where to send your display video. Each time
you press the combination of keys you will
step to the next choice. The choices, in order
are: built-in display only, external monitor
only, both built-in display and external
monitor.
Move the display and the brightness control
until you have adequate visibility.
Press any button the keyboard, or move the
mouse to restore operation. If that fails, push
the Power/Suspend/Resume button. (The
display may be shut off by Stanby mode,
Auto Suspend or Video Timeout)
Contact your support representative.
Press any button on the keyboard, or move
the mouse to restore operation. If that fails,
push the Power/Suspend/Resume button.
Check your power management settings, or
close your applications and go to the Power
Savings menu of the setup utility to adjust the
timeout values to better suit your operation
needs.
Press any button on the keyboard, or move
the mouse to restore operation. If that fails,
push the Power/Suspend/Resume button.
(The display may be shut off by Standby
Mode, Auto Suspend or Video Timeout)
Check the Closed Cover switch.
31