Fujitsu D1837 Manual técnico - Página 30

Navegue en línea o descargue pdf Manual técnico para Placa base Fujitsu D1837. Fujitsu D1837 48 páginas. Siemens

Mounting heat sink

Be sure to use heat conducting material between the processor and the heat sink. If a heat

conducting pad (rubber-like foil) is already applied to the heat sink, then use it. Otherwise you must

apply a very thin layer of heat conducting paste.

Heat conducting pads can only be used once. If you remove the heat sink, you must clean it and

apply new heat conducting paste before you remount it.

Please note that, depending on the heat sink used, different heat sink mounts are required on the

mainboard.

A26361-D1837-Z120-1-7419, Edition 1

Installing and removing processors

►

Depending on the configuration variant, you

must pull a protective foil off the heat sink or

coat the heat sink with heat conducting

paste before fitting it.

►

Secure the heat sink - depending on the

model - with four screws or push it into the

mounts.

English - 21