Fujitsu MB91460 SERIES Nota de aplicación - Página 18
Navegue en línea o descargue pdf Nota de aplicación para Placa base Fujitsu MB91460 SERIES. Fujitsu MB91460 SERIES 23 páginas. 32-bit microcontroller
También para Fujitsu MB91460 SERIES: Manual del usuario (45 páginas), Primeros pasos (41 páginas), Nota de aplicación (26 páginas), Nota de aplicación (29 páginas), Nota de aplicación (29 páginas)
Imprimir página
5 Accemic MDE Monitor Debugger
This chapter describes the debugging on MB91461 by use of the Accemic MDE Monitor
Debugger.
The Accemic MDE Monitor Debugger is a third party tool for debugging the MB91461R. It
provides an own IDE surface for debugging.
To use the Accemic MDE you have to add two files delivered with the MDE environment
(monitorFR.asm,
monitor.h)
configuration). Also take care not to locate your project sections overlapped with MDE
sections.
Accemic MDE needs following address ranges:
S_Addr. -E_Addr.
0003FF00-0003FFFF
000FFB00-000FFBFF
007E0000-007EFFFF
Because normally the Accemic MDE handles clock startup, please remove clock setting
section fro startup. All clock settings will be made to monitor kernel.
After you have build your project with the settings mentioned above, please check settings
on starterkit shown below and start Accemic MDE software.
Table 9: Jumper and switches on SK91461 for Accemic MDE Monitor Debugger
As first step you have to select processor type. Press '+' button in processor window to add
MB91461. Processor Setup dialog opens to choose appropriate microcontroller. Make your
selections and click 'OK' to get to the next menu. Here the clock settings for the monitor
kernel are made. Press 'Next' and follow the menu to set for example communication COM
port and access code. After all settings are finished, the monitor kernel has to be
downloaded to MCU. Please set microcontroller to programming mode (MD[0:3] = L) and
follow the instructions.
MCU-AN-300029-E-V1
MB91461 Emulation
Chapter 5 Accemic MDE Monitor Debugger
to
your
Softune
Size
Section Type Al
00000100
DATA
00000100
CONST N R--I 00 ABS
00010000
CONST N R--I 00 ABS
Name (Switches)
RES
P15_3
P15_2
INT0
MD0
MD1
MD2
MD3
Name (Jumpers)
P21_0
P21_1
P15_3
P15_2
- 18 -
Workbench
project
Sec.(Top 81)
N RW-- 00 ABS
ACC_MDATA
ACC_UDATA
ACC_MCODE
Setting
BRK
Don't care
Don't care
L
H
L
L
L
Setting
Connection
Connection
Don't care
Don't care
© Fujitsu Microelectronics Europe GmbH
(STANDALONE