Fujitsu SK-91460T-144PMC-GPIO Manual del usuario - Página 38
Navegue en línea o descargue pdf Manual del usuario para Placa base Fujitsu SK-91460T-144PMC-GPIO. Fujitsu SK-91460T-144PMC-GPIO 47 páginas. Mb91460 series
Imprimir página
The software now automatically writes a flash loader to the microcontroller, does a blank
check and erases the flash memory if necessary. After that the user application is
programmed to the embedded flash memory.
During this sequence the actual progress status can be seen by checked off steps on the
"Automatic" sheet and the messages below in the message box.
If the programming sequence is ended successfully, you will receive the output shown in
figure 7.
The Addresses 0x14:8000 to 0x14:800F cannot be written in automatic mode. This is a built
in security feature to prevent unintended writing to the Flash Security Vectors and Boot
Security Vectors. Otherwise it would be possible to secure flash content and to lock the
microcontroller for serial programming/reading/erasing by not being able to enter the internal
loader anymore. If you want to use these features explicitly, you have to program these
dedicated addresses by using the "Prog Word" Function of the step-by-step mode.
Figure 6-3: Successful Programming in Automatic Mode
6.2 Synchronous Mode
In order to program the Flash-ROM synchronously special third-party soft- and hardware has
to be used, e.g. GALEP-4 from www.conitec.de. This tool is not available for free.
A dedicated Flash programming socket (X1) is provided on the evaluation-board for direct
connection to this programmer.
FMEMCU-UG-910074-11
SK-91460T-144PMC-GPIO User Guide
Chapter 6 Programming the internal Flash
n/c 1
n/c 3
RST 5
SOT4 7
VCC 9
Figure 6-4: X1 Flash Programming Socket
- 38 -
2 n/c
4 n/c
6 SIN4
8 SCK4
10 GND
© Fujitsu Microelectronics Europe GmbH