Fujitsu SK-96320-80PMC Manual del usuario - Página 13
Navegue en línea o descargue pdf Manual del usuario para Placa base Fujitsu SK-96320-80PMC. Fujitsu SK-96320-80PMC 34 páginas.
También para Fujitsu SK-96320-80PMC: Manual del usuario (34 páginas), Manual del usuario (34 páginas)
Imprimir página
3.2 Power Supply (JP: 29, 37, 43, 44, 45)
Two onboard voltage regulators provide stabilized 5V and 3.3V supplies to the MCU and
peripherals. Even though they are thermally protected against overload, care must be taken
when supplying current for additional circuitry.
The LIN Vs line can be connected directly to the input supply of the board by JP44 and
JP45. In this case, the input voltage to the board has to be suitable for the connected bus
devices (mostly around 12V). Since there is a protection diode between Vin and Vs, it is not
possible to power the board over the LIN bus.
JP29 Selects the MCU IO and peripherals Vcc voltage (3.3V or 5V)
JP37 Connects the MCU IO voltage to Vcc. Could be used for current measurement.
JP43 Main supply on / off
JP44 Connects LIN Vs (Pin 1 of X8) to Vin
JP45 Connects LIN Vs (Pin 1 of X6) to Vin
Jumper
(VDD5 3V/5V)
(Mains on/off)
(VBAT_A)
(VBAT_B)
© Fujitsu Microelectronics Europe GmbH
Downloaded from
Elcodis.com
electronic components distributor
Setting
JP29
1 - 2
2 - 3
JP37
Closed
(VDD5)
Open
JP43
Closed
Open
JP44
Closed
Open
JP45
Closed
Open
SK-96320-80PMC User Guide
Chapter 3 Jumpers and Switches
Description
MCU / Peripherals @ 5V
MCU / Peripherals @ 3.3V
Power supply Vcc connected to VDD5
Power supply Vcc not connected to VDD5
The board is switched on
The board is switched off
Vs of LIN A is powered by the board
No voltage supply to Vs of LIN A
Vs of LIN B is powered by the board
No voltage supply to Vs of LIN B
- 13 -
FMEMCU-UG-960010-12