Indesit KN6 G110SA/NL Manual de instrucciones - Página 25

Navegue en línea o descargue pdf Manual de instrucciones para Cocinas Indesit KN6 G110SA/NL. Indesit KN6 G110SA/NL 32 páginas. Cooker and oven

Imprimir página

condition may be checked.

• Is shorter than 1500 mm.

• Fits firmly into place at both ends, where it will

be fixed using clamps that comply with current

regulations.

! If one or more of these conditions is not fulfilled

or if the cooker must be installed according to the

conditions listed for class 2 - subclass 1 appliances

(installed between two cupboards), the flexible steel

hose must be used instead (see below).

Connecting a flexible jointless stainless steel pipe

to a threaded attachment

Make sure that the hose and gaskets comply with

current national legislation.

To begin using the hose, remove the hose holder on

the appliance (the gas supply inlet on the appliance is

a cylindrical threaded 1/2 gas male attachment).

! Perform the connection in such a way that the hose

length does not exceed a maximum of 2 metres,

making sure that the hose is not compressed and does

not come into contact with moving parts.

Checking the tightness of the connection

When the installation process is complete, check the

hose fittings for leaks using a soapy solution. Never

use a flame.

Adapting to different types of gas

It is possible to adapt the appliance to a type of gas

other than the default type (this is indicated on the

rating label on the cover).

Adapting the hob

Replacing the nozzles for the hob burners:

1. Remove the hob grids and slide the burners off their

seats.

2. Unscrew the nozzles using a 7 mm socket spanner

(see gure), and replace them with nozzles suited to

the new type of gas (see Burner and nozzle speci cations

table).

3. Replace all the components

by following the above

instructions in reverse.

Adjusting the hob burners'

minimum setting:

1. Turn the tap to the minimum

position.

2. Remove the knob and adjust

the regulatory screw, which is positioned inside or next

to the tap pin, until the flame is small but steady.

! If the appliance is connected to a liquid gas supply,

the regulatory screw must be fastened as tightly as

possible:

3. While the burner is alight, quickly change the

position of the knob from minimum to maximum and

vice versa several times, checking that the flame is not

extinguished.

! The hob burners do not require primary air

adjustment.

! After adjusting the appliance so it may be used with

a different type of gas, replace the old rating label with

a new one that corresponds to the new type of gas

(these labels are available from Authorised Technical

Assistance Centres).

! Should the gas pressure used be different (or vary

slightly) from the recommended pressure, a suitable

pressure regulator must be fitted to the inlet hose in

accordance with current national regulations relating to

"regulators for channelled gas".