Indesit KN6E61A/FR Manual de instrucciones - Página 11

Navegue en línea o descargue pdf Manual de instrucciones para Cocinas Indesit KN6E61A/FR. Indesit KN6E61A/FR 28 páginas. Cooker and oven

Imprimir página

Installation

! Please keep this instruction booklet in a safe place for

future reference.. Make sure the booklet remains with

the appliance if it is sold, given away or moved.

! Please read this manual carefully: it contains

important information on installation, operation and

safety.

! The appliance must be installed by a qualified

professional in accordance with the instructions

provided.

! Any necessary adjustment or maintenance must be

performed after the cooker has been disconnected

from the electricity supply.

Positioning and levelling

! The appliance may be installed alongside any

cupboards whose height does not exceed that of the

hob surface.

! Make sure that the wall which is in contact with the

back of the appliance is made from a non-flammable,

heat-resistant material (T 90°C).

To install the appliance correctly:

• Place it in the kitchen, the dining room or the studio

flat (not in the bathroom).

• If the top of the hob is higher than the cupboards,

the appliance must be installed at least 600 mm away

from them.

• If the cooker is installed underneath a wall cabinet,

there must be a minimum distance of 420 mm

between this cabinet and the top of the hob.

HOOD

600

Min.

mm.

with the instructions listed in the relevant operating

manual.

* Only available in certain models.

This distance should be

increased to 700 mm

if the wall cabinets are

flammable (see fi gure).

•

Do not position

blinds behind the cooker

or less than 200 mm

away from its sides.

•

Any hoods must be

installed in accordance

Levelling

If it is necessary to level the

appliance, screw the adjustable

feet into the positions provided

on each corner of the base of

the cooker (see fi gure).

The legs* fit into the slots on the

underside of the base of the

cooker.

Electrical connection

Fitting the power supply cable

To open the terminal board:

• Insert a screwdriver into the side tabs of the terminal

board cover.

• Pull the cover to open it.

below:

• Loosen the cable clamp screw and the wire contact

screws.

! The jumpers are pre-set at the Factory for 230 V

single-phase connection (see fi gure).

230V ~

H05RR-F 3x4 CEI-UNEL 35363

H05VV-F 3x4 CEI-UNEL 35746

• To carry out the electrical connections as shown in

the figures, use the two jumpers inside the box (see

fi gure - labelled "P").

To install the cable,

follow the instructions