Indesit XWDE 961680 Manual de instrucciones - Página 15

Navegue en línea o descargue pdf Manual de instrucciones para Lavadora/secadora Indesit XWDE 961680. Indesit XWDE 961680 20 páginas.

Imprimir página

Troubleshooting

Your washing machine could occasionally fail to work. Before contacting the Technical Assistance Service (see " Service"),

make sure that the problem cannot be solved easily using the following list.

Problem:

The machine does not switch on.

The wash cycle does not start.

The washer-dryer does not dry.

The machine does not fill with

water or 'H20' in the display.

The machine continuously fills with

water and continually drains away

or Water left in the drum

or Stuck on wash.

The machine does not drain or spin

- (error lights flashing).

The machine does spin.

The machine does not heat or poor

wash results.

The programme takes too long.

The Display sticks at one 'time to

end' for more than 1 Minute or the

Display changes the estimated 'Time

to End' during the programme.

The machine vibrates a lot during

the spin cycle.

Push&Wash+Dry does not activate.

Possible causes / Solutions:

• The appliance is not plugged into the socket fully, or not enough to make contact.

• There is no power to the socket, or the fuse has blown in the mains plug.

• The door is not closed properly.

• The ON/OFF button has not been pressed.

• The START/PAUSE button has not been pressed.

• The water tap has not been turned on to allow water to flow into the machine.

• A delayed start has been set.

• Check the 2 sections above.

• The "Drying" is set to "OFF".

• The water inlet hose is kinked.

• The water inlet hose is not connected to the water supply.

• The water pressure is too low.

• The water tap has not been turned on to allow water to flow into the machine.

• There is no water supply to the house.

• The inlet valve filter is blocked.

• The START/PAUSE button has not been pressed.

• The top of the drain hose is too low - It must be fitted at a height between 65

and 100 cm from the floor (see "Installation").

• The drain hose is connected incorrectly to the sink trap allowing water to run

into the machine, the drain hose must be positioned higher than the bottom of

the sink to prevent water flowing down the drain hose.

• The end of the drain hose has been pushed too far down the standpipe, the

'U' bracket should be fitted 100 mm from the end of the drain hose.

• The Pump filter is blocked.

• The drain hose is kinked (see "Installation").

• New Installation - The blanking cap or spigot has not been removed if

connected under a sink.

• The drain hose or sink trap is blocked.

• The "Spin Speed" is set to "OFF".

• The 'Temperature' is set to "OFF".

• Programme times will vary due to water pressure, the incoming water temperature

and if the wash load goes out of balance. This will increase the programme times

accordingly (see ' The machine wont spin properly' next page).

• The display time is for guidance only - it is not a precise time to finish and

may vary.

• The feet have not been adjusted, enabling the machine to rock.

• New Installation - Either the Transit Bolts including the plastic spacers, or the

Polystyrene Packaging have not been removed when installing the machine.

• The machine is trapped between cabinets and/or walls.

• The load is in a slight out of balance condition and machine is spinning, but at

a lower speed.

• After switching on the machine a control other than Push&Wash+Dry was

activated. Switch the machine off and press the Push&Wash+Dry button.