Indesit PI 640 A Manual de instrucciones - Página 5
Navegue en línea o descargue pdf Manual de instrucciones para Placa Indesit PI 640 A. Indesit PI 640 A 11 páginas.
También para Indesit PI 640 A: Manual de instrucciones (15 páginas)
Imprimir página
Setting the burners to minimum:
GB
1. Turn the tap to the low flame position.
IE
2. Remove the knob and adjust the adjustment screw,
which is positioned in or next to the tap pin, until
the flame is small but steady.
4. Some appliances have a safety device
(thermocouple) fitted. If the device fails to work
when the burners are set to the low flame setting,
increase this low flame setting using the adjusting
screw.
5. Once the adjustment has been made, replace the
seals on the by-passes using sealing wax or a
similar substance.
16
3. Having adjusted the
flame to the required
low setting, while the
burner is alight, quickly
change the position of
the knob from minimum
to maximum and vice
versa several times,
checking that the flame
does not go out.
If the appliance is connected to liquid gas, the
regulation screw must be fastened as tightly as
possible.
Once this procedure is finished, replace the old
rating sticker with one indicating the new type of gas
used. Stickers are available from any of our Service
Centres.
Should the gas pressure used be different (or vary
slightly) from the recommended pressure, a suitable
pressure regulator must be fitted to the inlet pipe (in
order to comply with current national regulations).
DATA PLATE
voltage of 220-230V ~ 50/60Hz
Electrical
or 220-240V ~ 50/60Hz (see
connections
data plate ) maximum power
absorbed 1500W
This appliance conforms to the
following European Economic
Community directives:
-73/23/EEC dated 19/02/73 (Low
Voltage) and subsequent
amendments
- 89/336/EEC dated 03/05/89
(Electromagnetic Compatibility)
and subsequent amendments
- 93/68/EEC dated 22/07/93 and
subsequent amendments.
- 90/336/EEC dated 29/06/90
(Gas) and subsequent
amendments.
- 2002/96/EC