AEG ARCTIS Manual de instrucciones - Página 22

Initial Start-Up

1. Insert plug into mains socket.

2. Press ON/OFF button.

The green stand-by (mains confirmation) display lights up. The

temperature display shows the current temperature in the appliance

(ACTUAL temperature). The red warning indicator will flash to indicate

that the necessary storage temperature has not yet been reached.

After the appliance has been switched on, the warning tone is sup-

pressed until such time as the DESIRED temperature is reached. If,

instead of using the ON/OFF button, the appliance has been switched

off by removing the plug from the mains, the warning tone will be acti-

vated when the appliance is started up again.

In the delivery state, your appliance is present in the operation mode

"Freezing".

If the appliance was once in operation, it restarts in the operation

mode, which was set prior to switching off.

If necessary, switch over the appliance with the following steps

between the operating modes "Freezing" and "Cooling":

1. Hold down the ON/OFF button and the WARNING OFF button simulta-

neously for 5 seconds.

• When the setting is switched from "Freezing" to "Cooling" "FC"

(Freezing -> Cooling) appears in the temperature display, an acoustic

signal confirms the change and the temperature display changes to

flashing figures (DESIRED temperature cooling mode 5 °C). Using the

temperature setting buttons, the required temperature for the cool-

ing mode can now be entered.

• When the setting is switched from "Cooling" to "Freezing" "CF" (Cool-

ing -> Freezing) appears in the temperature display, an acoustic sig-

nal confirms the change and the temperature display changes to

flashing figures (DESIRED temperature freezing mode -18 °C). Using

the temperature setting buttons, the required temperature for the

freezing mode can now be entered.

The operation mode, in which your appliance is at the moment, is

identifiable if the temperatures can be set above or below 0 °C.