A-Neuvideo HD-44G Manual de instrucciones - Página 3
Navegue en línea o descargue pdf Manual de instrucciones para Interruptor A-Neuvideo HD-44G. A-Neuvideo HD-44G 6 páginas. Ethernet (tcp) set up
También para A-Neuvideo HD-44G: Manual de instrucciones (20 páginas), Manual de instrucciones (20 páginas)
Imprimir página
STEP 1. NETWORK THE UNIT
(1-1) Set up the network of the unit.
(1-1.1) Plug the unit into a power outlet.
(1-1.2) Plug the Ethernet cable to the unit and the other end to an open port on your hub.
(1-1.3) Turn the unit on.
(1-2) Set up your computer in the same network of the unit.
(1-2.1) Go to start and click on control panel.
(1-2.2) Double click on Network Connections.
(1-2.3) Click on Properties.
(1-2.4) Click to select Internet Protocol (TCP/IP) and click Properties.
Picture 1-2.3
(1.2-5) Make note of the numbers for IP address and Default gateway.
(1.2-6) Choose use the following IP address and key in the IP number of the unit:
IP address: 192.168.0.x
The fi rst three numbers must be 192.168. 0 while the last number must not be: number 3; lower than 255; one that has been
assigned to another device. After the numbers are set, press enter.
Picture 1-2.6
SETUP THE NETWORK (1)
Default Gateway: 192.168.0.x
Picture 1-2.4
2
1. You can also locate the unit on any
network provided you setup port forwarding
on your router.
2. You can also use an external controller
provided it is capable of communication to
a COM port AND you can install the re-direct
software.