AEG S51800DSW0 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Congelador AEG S51800DSW0. AEG S51800DSW0 44 páginas.

Operation

• Regularly examine the drain in the refrigerator for defrosted water. If necessary, clean

the drain. If the drain is blocked, water will collect in the bottom of the appliance.

Installation

For electrical connection carefully follow the instructions given in specific paragraphs.

• Unpack the appliance and check if there are damages on it. Do not connect the appli-

ance if it is damaged. Report possible damages immediately to the place you bought it.

In that case retain packing.

• It is advisable to wait at least four hours before connecting the appliance to allow the oil

to flow back in the compressor.

• Adequate air circulation should be around the appliance, lacking this leads to overheat-

ing. To achieve sufficient ventilation follow the instructions relevant to installation.

• Wherever possible the back of the product should be against a wall to avoid touching or

catching warm parts (compressor, condenser) to prevent possible burn.

• The appliance must not be located close to radiators or cookers.

• Make sure that the mains plug is accessible after the installation of the appliance.

• Connect to potable water supply only.

Service

• Any electrical work required to do the servicing of the appliance should be carried out by

a qualified electrician or competent person.

• This product must be serviced by an authorized Service Centre, and only genuine spare

parts must be used.

Environment Protection

This appliance does not contain gasses which could damage the ozone layer, in either its

refrigerant circuit or insulation materials. The appliance shall not be discarded together

with the urban refuse and rubbish. The insulation foam contains flammable gases: the ap-

pliance shall be disposed according to the applicable regulations to obtain from your local

authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchang-

er. The materials used on this appliance marked by the symbol

OPERATION

Switching on

Insert the plug into the wall socket.

Turn the Temperature regulator clockwise to a medium setting.

Switching off

To turn off the appliance, turn the Temperature regulator to the "O" position.

4) If a water connection is foreseen.

are recyclable.