AEG SANTO C 7 14 40 i Instrucciones de uso e instalación - Página 14
Navegue en línea o descargue pdf Instrucciones de uso e instalación para Congelador AEG SANTO C 7 14 40 i. AEG SANTO C 7 14 40 i 14 páginas. Integrating fridge freezer
También para AEG SANTO C 7 14 40 i: Instrucciones de uso e instalación (29 páginas)
Imprimir página
Symptom
Appliance is not switched on
Mains plug is not plugged in
or is loose.
Appliance does not work.
Fuse has blown or is defective.
Socket is defective.
Appliance cools too much.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an exten-
ded period.
The food is too warm.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Interior lighting does not work.
Light bulb is defective.
Heavy build up of frost, possi-
Door seal is not air tight (pos-
bly also on the door seal.
sibly after reversing the door).
The compressor does not start
This is normal, no error has
immediately after changing
occurred.
the temperature setting.
Water on the floor or on sto-
Water drain hole is blocked.
rage shelves.
If, after carrying out the necessary checks there is still a fault with your
appliance please contact your local AEG Service Force Centre.
In guarantee customers should ensure that the suggested checks have
been made as the engineer will make a charge if the fault is not a
mechanical or electrical breakdown.
Please note that proof of purchase is required for any in-guarantee service
calls.
14
Possible Cause
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if neces-
sary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature control
knob to a warmer setting.
Please look in the "Initial Start
Up" section.
Open the door only as long as
necessary.
Turn the temperature control
knob to a colder setting.
Please look in the "Installation
location" section.
Please look in the "Changing
the Light Bulb" section.
Carefully warm the leaking
sections of the door seal with
a hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand until it sits cor-
rectly.
The compressor starts after a
period of time.
See the "Cleaning and Care"
section.
Changing the light bulb
Warning! There is a risk of electric shocks! Before changing the light
bulb, switch off the appliance and unplug it. Light bulb data: 220-240 V,
max. 15 W
1.
To switch off the appliance, turn the
temperature control knob to position
"0".
2.
Unplug the mains plug.
3.
To change the light bulb, remove the
screw from the light bulb cover.
4.
Unhook the light bulb cover as
shown.
5.
Change the defective light bulb.
6.
Refit the light bulb cover and the
screw.
7.
Put the refrigerator back into opera-
tion.
AEG65
15