AEG SANTO C 7 18 40-4I Instrucciones de uso e instalación - Página 16

Navegue en línea o descargue pdf Instrucciones de uso e instalación para Congelador AEG SANTO C 7 18 40-4I. AEG SANTO C 7 18 40-4I 28 páginas. Integrating fridge freezer
También para AEG SANTO C 7 18 40-4I: Instrucciones de uso e instalación (15 páginas), Instrucciones de uso e instalación (28 páginas), Instrucciones de uso e instalación (24 páginas), Instrucciones de uso e instalación (25 páginas), Instrucciones de uso e instalación (28 páginas), Instrucciones de uso e instalación (32 páginas), Instrucciones de funcionamiento e instalación (32 páginas), Instrucciones de uso e instalación (14 páginas), Manual del usuario (44 páginas)

Imprimir página
AEG SANTO C 7 18 40-4I Instrucciones de uso e instalación
Symptom
Appliance does not work.
Appliance cools too much.
The food is too warm.
Interior lighting does not work.
Heavy build up of frost, possi-
bly also on the door seal.
The compressor does not start
immediately after changing
the temperature setting.
Water on the floor or on sto-
rage shelves.
If, after carrying out the necessary checks there is still a fault with your
appliance please contact your local AEG Service Force Centre.
In guarantee customers should ensure that the suggested checks have
been made as the engineer will make a charge if the fault is not a
mechanical or electrical breakdown.
Please note that proof of purchase is required for any in-guarantee service
calls.
16
Possible Cause
Appliance is not switched on
Mains plug is not plugged in
or is loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an exten-
ded period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air tight (pos-
sibly after reversing the door).
This is normal, no error has
occurred.
Water drain hole is blocked.
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if neces-
sary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature control
knob to a warmer setting.
Please look in the "Initial Start
Up" section.
Open the door only as long as
necessary.
Turn the temperature control
knob to a colder setting.
Please look in the "Installation
location" section.
Please look in the "Changing
the Light Bulb" section.
Carefully warm the leaking
sections of the door seal with
a hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand until it sits cor-
rectly.
The compressor starts after a
period of time.
See the "Cleaning and Care"
section.