AEG 335 D Manual de instrucciones de instalación y funcionamiento - Página 12

Navegue en línea o descargue pdf Manual de instrucciones de instalación y funcionamiento para Campana de ventilación AEG 335 D. AEG 335 D 14 páginas. Electrolux cooker hood operating and installation instructions de 6250, de 6260, chde 6260, 335 d
También para AEG 335 D: Instrucciones de uso e instalación (16 páginas)

AEG 335 D Manual de instrucciones de instalación y funcionamiento
Active
This filter is used when the hood functions for internal recycling.
carbon filter
The original AEG active carbon filter should be used (see Special
accessories).
It is neither washable nor reusable.
In normal cooking conditions, we recommend that it be replaced
every 4 months.
To replace the active carbon filter, push the locking tabs E
inwards and the filter downwards (see diagram on pag. 4).
When ordering a new active carbon filter, indicate the model
description and fan hood serial number. This information can be
found on the rating plate inside the appliance.
Filters can be ordered at any AEG retailer.
Warning: always disconnect the hood from the mains power

Cleaning

supply before cleaning it.
Never insert pointed objects in the motor's protective grille.
Wash the outside surfaces using a mild detergent solution.
Never use caustic detergents or abrasive brushes or pow-
ders.
Only ever clean the switch panel and filter grille using a damp
cloth and mild detergents.
It is extremely important to clean the unit and change the
filters at the recommended intervals. Failure to do so will
cause grease deposits to build up that could constitute a fire
hazard.
Always turn off the electricity before replacing lamps:
Replacing
the lamps
1) Remove the grid in order to check the lamps and replace them
2) Unscrew the lamps that do not work and replace them with
If the light does not function, check that the lamps are properly
screwed-in before contacting the AEG Service Dept.
Attention
Failure to observe the instructions on cleaning the unit and
changing the filters will cause a fire hazard. You are therefore
strongly recommended to follow these instructions.
12
if necessary.
40W max lamps (E14).