AEG X69453MVO UK Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Campana de ventilación AEG X69453MVO UK. AEG X69453MVO UK 20 páginas. Cooker hood
También para AEG X69453MVO UK: Manual del usuario (36 páginas), Manual de instalación (12 páginas)

Imprimir página

MAINTENANCE AND CLEANING

Opening and locking panels

• Open the Panels by pulling from the centre.

• The top panel is locked by means of a rod, the mobile end of

which is inserted into the hole provided on the side of the Hood

body.

• The lower panel is unlocked by removing the fixing pin on the

left to open it. It is fitted with a safety cable to prevent it from

dropping down and hitting the lower part of the hood.

Before carrying out any maintenance or leaning isolate

the cooker hood from the mains supply.

The cooker hood must be kept clean, as a build up of

grease or fat can be a fire hazard.

External Cleaning

The metal casing, grille and chimney should be cleaned at least

once a month to keep it looking like new. Wipe over the hood

with a soft cloth wrung out in mild

soapy water and then dry thoroughly.

Never use scouring pads or abrasive cleaners as they may scratch

or damage the surfaces.

Always wear protective gloves when cleaning the hood.

Never use scouring pads or abrasive cleaners.

Never use excessive amounts of water when cleaning

particularly around the control panel.

Resetting the alarm signal

• Turn the Lights and the Suction motor off.

• Press button H and hold for at least 2 seconds, confirmation

is provided by the fact that the Led goes out.

Metal Grease Filters

• These filters can be washed in a dishwasher, and need to be

cleaned when the Led on Button H lights up in a continuous

manner or at least once every approximately two months'

use, or more frequently in the case of particularly intensive

use.

To Remove the Grease Filter

• Open the panel by pulling from the center.

• Remove the Filters one at a time, supporting them with one

hand while you pull the lever down with the other.

• Wash the Filters without bending them, and leave them to

dry before replacing them.

• Replace the filters, taking care to ensure that the handle is

fac-ing outwards.

MAINTENANCE AND CLEANING